I made a batch of these and I have two left.
They are made from O1 tool steel, heat treated to 62 Rockwell then three tempering cycles bringing them down to 56-58 Rockwell. Cerakote done by a local shop, colors are tungsten gray and graphite black.
As of right now they do NOT have edges on them. I can do an edge on one side, both or leave dull. That's up to the buyer.
Located in Yakima
Asking $125/each shipped.
Here is a thread that shows the machining process:
http://www.northwestfirearms.com/in...s...-I-mean-"tactical-letter-openers".177877/
They are made from O1 tool steel, heat treated to 62 Rockwell then three tempering cycles bringing them down to 56-58 Rockwell. Cerakote done by a local shop, colors are tungsten gray and graphite black.
As of right now they do NOT have edges on them. I can do an edge on one side, both or leave dull. That's up to the buyer.
Located in Yakima
Asking $125/each shipped.
Here is a thread that shows the machining process:
http://www.northwestfirearms.com/in...s...-I-mean-"tactical-letter-openers".177877/