Quantcast
  1. Sign up now and join over 35,000 northwest gun owners. It's quick, easy, and 100% free!

SOLD or moved - Battlecomps, Aimpoint, und mehr - AR15 components

Discussion in 'Part & Accessory Classifieds' started by Ben Beckerich, Jun 5, 2011.

  1. Ben Beckerich

    Ben Beckerich NW Oregon Bronze Supporter Bronze Supporter

    Messages:
    3,911
    Likes Received:
    2,325
    UPDATE- closing this one, most of the stuff's sold, what's not has been moved to this thread:

    http://www.northwestfirearms.com/pa...-sights-muzzle-devices-stocks-mounts-etc.html


    howdy

    ---

    $70 - New Aimpoint QRP mount WITH riser and longer screws for use with AR-15 - new style with updated knob

    $120 - Battlecomp 1.0 - approximately 3,000 rounds through it, shows plenty of wear in the black-oxide finish (which wears easily), but otherwise fine. very small amount of port erosion.

    SOLD $110 - Battlecomp 1.5 removed/repaired - this was previously permanently attached to a weapon, carefully removed, and repaired and refinished. perfectly useable, even permanently attachable. zero port erosion, round count under 500. PM me for more information on this 'un.

    SOLD $60 - Colt carry handle - slight wear, almost LNIB

    SOLD $25 - LMT tactical latch forged charging handle - it's worn, but still in perfectly serviceable condition

    SOLD $265 - Aimpoint CompC3 - 2 MOA dot - new battery, has seen some use, but still in perfectly serviceable condition - small scratches in anodize and one of the cap/gaskets is broken and could stand to be replaced

    buy both RDS and mount, and i'll throw in a FDE aimpoint rubber skin

    SPF $90 - Troy rear BUIS - M4 style - very good condition - black

    ---

    prices are shipped or FTF in the SE Columbia County area and are OBO - no trades - PM for info - cash or paypal GIFT (or you pay fee) only -no e-check-, NO personal checks - pics available for serious interest - thanks



    pix - the BUIS is dusty, but otherwise almost LNIB.. same for the mount. the battlecomp 1.5 is currently wearing gray primer- i can paint it flat black, brown, tan, OD.. even red, orange, blue, whatever, or leave it primer- your choice.

    100_2130.jpg
    100_2131.jpg
    100_2132.jpg
    100_2133.jpg
    100_2138.jpg
    100_2140.jpg
    100_2142.jpg
    100_2143.jpg
    100_2144.jpg

    100_2130.jpg

    100_2131.jpg

    100_2132.jpg

    100_2133.jpg

    100_2138.jpg

    100_2140.jpg

    100_2142.jpg

    100_2143.jpg

    100_2144.jpg
     
  2. madcratebuilder

    madcratebuilder Ardenwald, OR Well-Known Member

    Messages:
    1,278
    Likes Received:
    175
    PM sent on LMT tactical latch.
     
  3. WFO

    WFO Cottage Grove Active Member

    Messages:
    142
    Likes Received:
    49
    Can you send me pics of the Aimpoint and QRP mount?

    Thanks
     
  4. WFO

    WFO Cottage Grove Active Member

    Messages:
    142
    Likes Received:
    49
    Is it a 2 or 4 MOA dot?
     
  5. Ben Beckerich

    Ben Beckerich NW Oregon Bronze Supporter Bronze Supporter

    Messages:
    3,911
    Likes Received:
    2,325
    2 MOA

    pix up
     
  6. WFO

    WFO Cottage Grove Active Member

    Messages:
    142
    Likes Received:
    49
    Looks good.

    PM sent.
     
  7. WFO

    WFO Cottage Grove Active Member

    Messages:
    142
    Likes Received:
    49
    $$ sent.
     
Thread Status:
Not open for further replies.