- Messages
- 228
- Reactions
- 126
SOLD
very nice ruger 10/22. very minimal round count through gun, not even a full federal brick. not sure exactly what model it is. has blued or parkerized barrel. has polymer trigger housing. sights are removed because i was using an archangel stock, but have them as spare parts. it's in the original stock right now, mainly because it's easier to take apart so i can show the modifications if need be. has lots of trigger mods including stoning and re-radius of hammer, adjustable set screw in sear, hole in trigger to adjust set screw in sear, adjustable set screw in housing for overtravel stop, trimmed hammer spring, trigger return spring removed and a bobby pin for a torsion spring is used instead, auto bolt release mod, and everything possible is polished. trigger pull weight is very low and very crisp, probably around a pound or two, will get exact pull weight later on. receiver was stripped and recoated in flat black. 9mm case used as extended mag release and 45 case used as charging handle(not pictured). complete bolt work done by que from rimfirecentral which includes jeweling, headspace adjusted, reworked extractor, firing pin profiled and cross pinned, and rear of bolt radiused. also has teflon bolt buffer. has factory 10 round mag, 2 25 round plastic mags, archangel stock, and every spare part i have. looking for $325 or trades. thanks a lot guys
trades (and cash if needed)
eotech or other red dot sight
streamlight tlr-1s/2s
s&w m&p 9mm threaded barrel or spec ops barrel
s&w m&p 9mm 17 round mags
arredondo mag extensions for m&p 9/40/357
ar 15 arredondo mag well
ar 15 magpul bad lever or similar
ar 15 extended mag release
ar 15 magpul pmag's regular or maglevel
good buis or magpul mbus gen2
magpul ms2 sling or similar
very nice ruger 10/22. very minimal round count through gun, not even a full federal brick. not sure exactly what model it is. has blued or parkerized barrel. has polymer trigger housing. sights are removed because i was using an archangel stock, but have them as spare parts. it's in the original stock right now, mainly because it's easier to take apart so i can show the modifications if need be. has lots of trigger mods including stoning and re-radius of hammer, adjustable set screw in sear, hole in trigger to adjust set screw in sear, adjustable set screw in housing for overtravel stop, trimmed hammer spring, trigger return spring removed and a bobby pin for a torsion spring is used instead, auto bolt release mod, and everything possible is polished. trigger pull weight is very low and very crisp, probably around a pound or two, will get exact pull weight later on. receiver was stripped and recoated in flat black. 9mm case used as extended mag release and 45 case used as charging handle(not pictured). complete bolt work done by que from rimfirecentral which includes jeweling, headspace adjusted, reworked extractor, firing pin profiled and cross pinned, and rear of bolt radiused. also has teflon bolt buffer. has factory 10 round mag, 2 25 round plastic mags, archangel stock, and every spare part i have. looking for $325 or trades. thanks a lot guys
trades (and cash if needed)
eotech or other red dot sight
streamlight tlr-1s/2s
s&w m&p 9mm threaded barrel or spec ops barrel
s&w m&p 9mm 17 round mags
arredondo mag extensions for m&p 9/40/357
ar 15 arredondo mag well
ar 15 magpul bad lever or similar
ar 15 extended mag release
ar 15 magpul pmag's regular or maglevel
good buis or magpul mbus gen2
magpul ms2 sling or similar
