I recently purchased a Quarter Circle large frame lower to work with .45 ACP upper. This uses large frame Glock magazines. Sent off and had it anodized and ready to assemble. I started the assembly and soon found out that I needed guidance in the assembly. I called the company and asked for an assembly drawing so I could finish it. There are a few parts that are not used in a standard AR-15 . I was told there is no assembly drawing and they offered to put it together for $25.
I have it almost all the way together and don't really want to send it out in the mail again. I just want to see if I put the parts in the right place.
Any pictures of a completed lower or some assembly drawings would finish this !
Thank
Skidder
I have it almost all the way together and don't really want to send it out in the mail again. I just want to see if I put the parts in the right place.
Any pictures of a completed lower or some assembly drawings would finish this !
Thank
Skidder