pogi

Discussion in 'Maintenance & Gunsmithing' started by 22many, Feb 10, 2012.

  1. 22many

    22many
    PNW
    Well-Known Member

    Messages:
    1,146
    Likes Received:
    294
    Pogi, when I told you that I made handguards for my tantal out of a 2x4 i figured Id post a pic so you didnt think it was wayyyyy ghetto. Well, didnt turn half bad and I still need to do some small router work then a final sand/stain.

    I figured it was better than the $90-$100 for ironwoods.
     
  2. kev1

    kev1
    seabeck,wa
    Member

    Messages:
    58
    Likes Received:
    18
    Those turned out nice. I dislike the ones that came new on mine. post a pic when finish is installed.
     
  3. pogi

    pogi
    Gresham, OR
    Active Member

    Messages:
    723
    Likes Received:
    83
    True Khyber, nice job!
     
  4. eganx

    eganx
    Kingston WA
    Active Member

    Messages:
    500
    Likes Received:
    187
    Did you use any sort of heat shield? Nice work BTW
     

Share This Page