Marlin/Glenfield model 60 parting out.

Discussion in 'Part & Accessory Classifieds' started by cyclesurvival, Mar 22, 2011.

Thread Status:
Not open for further replies.
  1. cyclesurvival

    cyclesurvival
    Vancouver
    Well-Known Member

    Messages:
    1,088
    Likes Received:
    55
    Parting out a model 60 tube feed. was parts gun and got what I needed. no tube, no barrel, no reciever, broken sear. all the other parts are good Pm what you need.
     
  2. STNOSU

    STNOSU
    Corvallis
    Member

    Messages:
    250
    Likes Received:
    12
    I know you said the tube is gone, but is the part with the spring that goes in the tube gone?
     
  3. cyclesurvival

    cyclesurvival
    Vancouver
    Well-Known Member

    Messages:
    1,088
    Likes Received:
    55
    They plastic follower? yes I have a couple. PM me you phone number.
     
  4. STNOSU

    STNOSU
    Corvallis
    Member

    Messages:
    250
    Likes Received:
    12
    Is that the spring thing inside of the tube you pull out? Its whitish and sticks out of the end a lil bit?
     
  5. cyclesurvival

    cyclesurvival
    Vancouver
    Well-Known Member

    Messages:
    1,088
    Likes Received:
    55
    I have a red one. round on the end.
     
  6. cyclesurvival

    cyclesurvival
    Vancouver
    Well-Known Member

    Messages:
    1,088
    Likes Received:
    55
    pictures
     
  7. PaulZ

    PaulZ
    Oregon City
    Active Member

    Messages:
    583
    Likes Received:
    198
    How is the stock? if you still have it
     
  8. wolfwistle

    wolfwistle
    lebanon
    Member

    Messages:
    164
    Likes Received:
    20
    P M sent
     
  9. cyclesurvival

    cyclesurvival
    Vancouver
    Well-Known Member

    Messages:
    1,088
    Likes Received:
    55
    PM answered, I dont have the stock, you can get a ATI stock for less then $50 to your door.
     
  10. cyclesurvival

    cyclesurvival
    Vancouver
    Well-Known Member

    Messages:
    1,088
    Likes Received:
    55
    I just got a 2 factory stock both in nice shape $40 each. And another older Glenfield mdl 60 $75
     
  11. phishisgroovin

    phishisgroovin
    Kent, Wa
    Member

    Messages:
    29
    Likes Received:
    1
    have all the screws to mount the reciever to the stock? i need to front and rear one.
     
  12. cyclesurvival

    cyclesurvival
    Vancouver
    Well-Known Member

    Messages:
    1,088
    Likes Received:
    55
    I will check
     
Thread Status:
Not open for further replies.

Share This Page