Ar15 Misc Parts and Accessories Magpul, Stocks, BCM, A2 and A1 grips, panels, Sight bases, Charging Handles

[eldbillbo]

Ad Type

1. For Sale

Manufacturer

Other / Not Listed

City

Oregon City

State

Oregon

$20 minimum FTF purchase can be combined with stuff from my other post.

Magpul Illumination Kit $15


Midlength Magpul Moe Handguards $35 each



Magpul Industries MOE Rifle Stock for AR-15/M-16, Mil-Spec $30 or $50 with mil-spec Buffer tube.




Colt Side Sling attachment VG+ $50


Gas tubes 1 carbine and several Mid-length Nitride finish $14each add $1 for roll pin.
Aluminum Gas blocks $15 each
Chopped A2 Front sight base $10
Steel top rail gas block $25 or $35 with mid gas tube
Chopped FSB need crappy chop could use some cleanup and paint with mid-length gas tube $20



Trinity Force Stock. This stock is over a 1" longer than most traditional Ar15 M4 stocks which is nice if you have longer arms or prefer a longer stock its in new condition and has a build-in rubber butt pad plenty of sling attachment points for loop and one for quick disconnect $30





Charging handle please note the grip part is a little bigger than older charging handles. $15




Magpul XTM Rail Panel Covers Stippled $10 (SOLD)


2 sets Magpul XTM Rail Panel Covers Not Stippled $10 per 4 pair set (SOLD)


BCM VG-S-KM-BLK VERT KMOD GRIP-SHRT $30





GRIPS


Retro A2 mottled grips with a small chunk missing $15



Colt A2 grip on the left 1/10" wider than most A2 grips marked with "F" said to be Colt take off but I think FN also marks theirs with just an F $20 (SOLD)
A2 grip on the right "3" Marked not sure who made it $5





Colored A2 Grips
From Left to right
Armalite Ghost Camo $10
Metallic Gold $5 (SOLD)
OD green $5(SOLD)
Green $5 (SOLD)





Spikes magpul style grip $10


Ambi Safety $25 (SOLD)





Grip screws $1 each

Read More

 

[blackbandet]

Hello,
I need parts to build an ar 15 lower
Receiver.

Your commercial stock, tube, buffer, spring, castle nut, etc to install I would need.
Also a a2 grip and screw, charging handle
Too. End plate

Trade for .22 ammo

 

[eldbillbo]

Hello,
I need parts to build an ar 15 lower
Receiver.

Your commercial stock, tube, buffer, spring, castle nut, etc to install I would need.
Also a a2 grip and screw, charging handle
Too. End plate

Trade for .22 ammo

Hello I sent you a PM

 

[blackbandet]

Hello,
I purchased new
Thanks

 

[Cjkacz]

Shipping available?

 

[eldbillbo]

Yes shipping is $8 if you can think of anything else you need that will fit in a flat rate box with the mount let me know.

 

[parsons_12b]

I will take the A2 upper per our PMs

 

[MfnLeadFarmer]

PMd

 

[Loc]

I know it's been 10 months, but if you still have the ambi safety, I'd like to purchase it.

 

[Ilikegunz]

I need a spring and buffer if you have some available?

 

[eldbillbo]

I do pm if you still need them