You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
Join the #1 community for gun owners of the Northwest
We believe the 2nd Amendment is best defended through grass-roots organization, education, and advocacy centered around individual gun owners. It is our mission to encourage, organize, and support these efforts throughout Oregon, Washington, Idaho, Montana, and Wyoming.
Discuss firearms and all aspects of firearm ownership
Join others in organizing against anti-gun legislation
Buy, sell, and trade in our classified section
Find nearby gun shops, ranges, training, and other resources
Discover free outdoor shooting areas
Stay up to date on firearm-related events
Share photos and video with other members
...and much more!
The trigger assembly fitting after being shaved down.
Not a pretty job, but it works and will be covered by the trigger assembly. Shaving the high walls was a no-brainer, but the shorter rims (near the bottom of the picture) was a bit trickier as it wasn't clear that they were obstructing the fitting. All told, I took maybe 1.5-2mm off each side.