Member 53328
- Messages
- 9,059
- Reactions
- 19,932
Let me first state that I am pretty new to the P320 platform. I just picked up a Compact slide today and after installing it on my grip module the FCU will not release the firing pin and will not reset. The trigger is basically dead.
I have put 2 other slides on the same module/FCU and they work without issue so I know it has to be something with the slide. The slide I picked up today is the FDE one and in the pictures it's obvious that there are differences in the machining. The slide goes on the module fine but simply won't cycle or engage the trigger.
I know Sig has done some voluntary updates on their products. Would this fall under that? Or is there an older FCU that will work with this slide that I can purchase? Without going back into the issue of them going off during a drop test.
Any help would be greatly appreciated. Thanks.
I have put 2 other slides on the same module/FCU and they work without issue so I know it has to be something with the slide. The slide I picked up today is the FDE one and in the pictures it's obvious that there are differences in the machining. The slide goes on the module fine but simply won't cycle or engage the trigger.
I know Sig has done some voluntary updates on their products. Would this fall under that? Or is there an older FCU that will work with this slide that I can purchase? Without going back into the issue of them going off during a drop test.
Any help would be greatly appreciated. Thanks.