- Messages
- 561
- Reactions
- 844
Had a couple boxes of Remington small pistol primers, and decided to give them a go.
I loaded up 200rnds of 38spl 158grn LSWC.
I changed things up and decides to use some of my A#2 since I have ~6lbs left and don't use it often.
Decided to load these warmer at 4grns. Still well under +P pressures.
My Dillon SQDB was great, no dumped primers or powder today.
I also ran another 100rnds of the same load using CCI SP primers since I was in a groove.
So all in all, 300rnds went by fast!
I did find plenty of 38spl case length differences, something I don't usually notice, but many cases had slight variations in height like they stretched unevenly over time. I may do an unnecessary trim run on a 100 cases to see how uniform I can get them, and if it really even matters.
I loaded up 200rnds of 38spl 158grn LSWC.
I changed things up and decides to use some of my A#2 since I have ~6lbs left and don't use it often.
Decided to load these warmer at 4grns. Still well under +P pressures.
My Dillon SQDB was great, no dumped primers or powder today.
I also ran another 100rnds of the same load using CCI SP primers since I was in a groove.
So all in all, 300rnds went by fast!
I did find plenty of 38spl case length differences, something I don't usually notice, but many cases had slight variations in height like they stretched unevenly over time. I may do an unnecessary trim run on a 100 cases to see how uniform I can get them, and if it really even matters.