- Messages
- 73
- Reactions
- 7
I have a brand new, unfired, Daniel Defense 300blk barrel that I have never put any ammo through. It has been mounted to an upper with muzzle device and gas block so handling marks ever-so-slightly exist. I decided to go a different route (25-45 sharps). Consequently I have this barrel that I'll never use. I had a local gunsmith pre drill the gas block set screw location. This will not come with a gas block or anything on the muzzle. It was purchased at Brownell's last year and I have receipts to show.
I can throw in the gas tube (Spikes Tactical, melonite), 300blk brass and some cheap plinkers.
Price is $275
I also have a few thousand 300blk converted brass. $140/1000
Manufacture specs:
Barrel Length 16"
Manuf. Process Cold Hammer Forged
Twist Rate 1:8
Muzzle Thread. 5⁄8×24 TPI (Threads Per Inch)
Material Chrome Moly Vanadium
Outside Finish Salt Bath Nitride
Diameter At Gas Port .750″
Barrel Extension A4
Profile S2W® [Strength 2 Weight]
Gas System Carbine Length
Barrel Caliber 300 BLK
ManufacturerDaniel Defense
I can throw in the gas tube (Spikes Tactical, melonite), 300blk brass and some cheap plinkers.
Price is $275
I also have a few thousand 300blk converted brass. $140/1000
Manufacture specs:
Barrel Length 16"
Manuf. Process Cold Hammer Forged
Twist Rate 1:8
Muzzle Thread. 5⁄8×24 TPI (Threads Per Inch)
Material Chrome Moly Vanadium
Outside Finish Salt Bath Nitride
Diameter At Gas Port .750″
Barrel Extension A4
Profile S2W® [Strength 2 Weight]
Gas System Carbine Length
Barrel Caliber 300 BLK
ManufacturerDaniel Defense
Last Edited: