Quantcast
  1. Sign up now and join over 35,000 northwest gun owners. It's quick, easy, and 100% free!

WTS Tapco AK flat bending Jig no Press required

Discussion in 'Part & Accessory Classifieds' started by Foureyes, Mar 22, 2010.

  1. Foureyes

    Foureyes Clackamas Co New Member

    Messages:
    23
    Likes Received:
    0
    Traded for this a while back, but decided I don't need it after all. I did see the last flat that was bent with this jig, though and it was true.

    Just need some 9/16 wrenches and sockets and rachet center flat and sadwhich it between the bards tighten the smaller bolts to sandwhich it it them install and lock nut the longer bolts put into gressed up jig and tighten the bolts alternating and doing only a little at a time dont over do one bolt keep them even untill it sucks it in and bends it pull it all the way through and whola bent receiver

    DSC01262.jpg
    DSC01263.jpg
    DSC01264.jpg
    DSC01265.jpg
    DSC01267.jpg
    DSC01269.jpg
    DSC01270.jpg
    DSC01272.jpg
    DSC01273.jpg

    also comes with jig for doing trigger gaurd rivets

    $175

    I also have a new in wrap tapco flat and a US made gas piston that I will sell with the jig for $15 each



    FTF PDX Clackamas is even better :thumbup:
     
    Last edited: Mar 22, 2010