Well, these seemed to work!

[Ironbar]

The only thing I noticed about this load is that it seemed a little...I don't know....soft? Not as snappy as a factory load- however most of the factory loads I've shot have been 115 gr. Might bump it up another .2 gr of powder.

Read More

 

[BigDog67]

If it's not broke, don't fix it.

 

[Certaindeaf]

I think you need to stretch it out to eighteen feet to see if they tumble.




lol

 

[Member 5605]

I down- load my hand loads. I don't need to run full power. I've found some really nice and consistent loads at the lower end. One is low enough that if you limp wrist it, the slide will fail to cycle. But man they shoot good.

 

[Stomper]

I down- load my hand loads. I don't need to run full power. I've found some really nice and consistent loads at the lower end. One is low enough that if you limp wrist it, the slide will fail to cycle. But man they shoot good.

So much fodder for "that thread".... but I'll abstain, this time!

 

[Certaindeaf]

I down- load my hand loads. I don't need to run full power. I've found some really nice and consistent loads at the lower end. One is low enough that if you limp wrist it, the slide will fail to cycle. But man they shoot good.

I go one further and only play call a duty.

 

[Member 5605]

I go one further and only play call a duty.

With rumble turned off?
(I have a legitimate reason though for weak loads. Bad hands)
What is your excuse basement dweller?

 

[Stomper]

With rumble turned off?
(I have a legitimate reason though for weak loads. Bad hands)
What is your excuse basement dweller?

Bad jeans (not genes)....

 

[DizzyJ]

Very nice!