VZ58 build.

[Letus]

Disclaimer: This is my VZ58 build. I have no responsibility whatsoever if you have any problem using my method. All firearms should be checked with gunsmiths to make sure they are safe to use. I have 6 US made parts in compliance with 922r.
I am aiming at low cost build. This is the cheapest method. Attached is my finished VZ58. Instructions will follow.

Read More

 

[Letus]

the receiver: US made of course
cut from 1 1/4 square tube .120 wall, 7 1/4" long. divide it evenly so spacing is .7"
Spacing between top rails 1.125
Spacing between top and bottom rails .380

 

[Heyjoe]

Very Cool!
Thanks for sharing

 

[Letus]

cut for trigger

 

[Letus]

safe fire selector
no full auto slot
lever on both sides

 

[Letus]

US made follower and floor plate

 

[Letus]

modify Zastava AK thumb hole stock to fit. Cut to lower about 10 degree so the iron sight will work OK. (only $5 or $10 for 4 at centerfire system)

 

[Letus]

weld to cut receiver from kit

 

[Letus]

I then cut about 2" of 3/4 round tube and machine then welded to make 16"+ barrel. I also machined gas piston to make 6th part to comply.
I missed a lot of pictures (busy building)
If you have questions, please ask, I will try to answer to the best of my knowledge

 

[JeremyK]

What Machine tools used? How tight of a Tolerance?

 

[Letus]

table saw, grinder/cutter, welder, drill press, Lathe for piston. Very little play if any.

 

[JeremyK]

Very cool shoot it yet? Also, did you heat treat the steel?

 

[Letus]

I tested on my previous build, this one is way better but not tested yet.
No heat treat necessary since this one doesn't use hammer. Also wall thickness is .120 and it fit really tight

 

[drewp]

I plan to build a couple, i have 2 receivers and 2 parts kits. 1 reciever is a 100% and 1 is an 80%...but dang man you rock for making it all yourself

 

[drewp]

do you have pic of what you did for the mag catch and bolt hold open plunger etc

 

[Letus]

I didn't leave a section to drill a hole for bolt hold open but added it at a later time
I myself bought 1 100% receiver 9 years ago but never got it done. I think it's harder to press fit the new barrel than build the whole thing.

 

[IronMonster]

Nice job, I am glad I clicked on this thread. It's a fine thing you are doing.