Quantcast
  1. Sign up now and join over 35,000 northwest gun owners. It's quick, easy, and 100% free!

TRADED

Discussion in 'Part & Accessory Classifieds' started by eldbillbo, Feb 2, 2012.

  1. eldbillbo

    eldbillbo clackamas New world samurai and a redneck none the less Bronze Supporter

    Messages:
    3,173
    Likes Received:
    895
    TRADED
     
  2. billdo

    billdo troutdale or Member

    Messages:
    49
    Likes Received:
    5
    I think I have one. Pm sent
     
  3. nilknarf

    nilknarf Beaverton Active Member

    Messages:
    173
    Likes Received:
    39
    I have one too if billdo's receiver doesn't work out (mine's a thick-wall slick-sided receiver)... PM also on the way...
     
  4. Artpro

    Artpro Salem, OR. Artpro Bronze Supporter

    Messages:
    492
    Likes Received:
    35
    nilknarf PM Sent
     
  5. eldbillbo

    eldbillbo clackamas New world samurai and a redneck none the less Bronze Supporter

    Messages:
    3,173
    Likes Received:
    895
    still lookin
     
  6. Garg

    Garg east of portland metro Hold my beer..... watch this Bronze Supporter

    Messages:
    1,188
    Likes Received:
    1,002
    PM sent
     
  7. eldbillbo

    eldbillbo clackamas New world samurai and a redneck none the less Bronze Supporter

    Messages:
    3,173
    Likes Received:
    895
    Colt ar15 SP1 receiver $85
    I have a Colt SP1 slab side receiver that i received in trade and decided to go a different route , some one did sear cut under it, which is not visible when installed . its a SP1 receiver with large front pivot but has a bushing installed to fit all small pin receivers just remove it if you don't need it . the finish on it original and quite nice

    has after market rear sight and no dust cover

    would trade if for a A1 receiver or a A3 flat top receiver with no feed ramps
    could trade towards a beater barrel that has extended feed ramp extensions
     
Thread Status:
Not open for further replies.