The "Liberator" a CAD designed pistol printed on 3D printer is successfully fired

Discussion in 'General Firearm Discussion' started by fireninja13, May 7, 2013.

  1. fireninja13

    fireninja13
    Newberg / Portland Metro
    Active Member

    Messages:
    531
    Likes Received:
    219
  2. fireninja13

    fireninja13
    Newberg / Portland Metro
    Active Member

    Messages:
    531
    Likes Received:
    219
  3. Brutus57

    Brutus57
    Skagit County
    Well-Known Member

    Messages:
    3,623
    Likes Received:
    6,427
    Old military manuals show you how to build something like this with wood, pipe, nail, spring etc. no electricity needed.

    Brutus Out
     
    ZA_Survivalist likes this.
  4. edslhead

    edslhead
    Vanc
    Platinum Supporter Platinum Supporter Gold Supporter Silver Supporter

    Messages:
    2,390
    Likes Received:
    5,061
    If I didn't have so many darn guns already, I'd sure give it a try.o_O
     
  5. Hook686

    Hook686
    Northern California
    Active Member

    Messages:
    662
    Likes Received:
    226
    Back in the day the radio antenna off a car was used with block of wood, spring, nail to make a zip gun, .22 lr caliber. It might be primary reason the auto makers went away from hollow radio antennas, as the antenna from the 1950's was perfect for .22 lr barrel.
     
  6. Flopsweat

    Flopsweat
    Slightly right of center
    Well-Known Member

    Messages:
    2,304
    Likes Received:
    2,948
    Word was that they were about as likely to blow up in your hand as they were to fire. And they were about as accurate as a SPLC study.
     
    Don H likes this.
  7. Hook686

    Hook686
    Northern California
    Active Member

    Messages:
    662
    Likes Received:
    226
    True, but at bad breath distance against a meat hook, or straight razor it was worth the risk.
     

Share This Page