- Messages
- 57
- Reactions
- 44
JavaScript is disabled
Our website requires JavaScript to function properly. For a better experience, please enable JavaScript in your browser settings before proceeding.
Suppressor Bore Alignment Rod
- Thread Starter clo5
- Start date
-
- Tags
- bore rod suppressor
- Messages
- 1,359
- Reactions
- 2,348
If you're looking to buy one, not just borrow one, you can pick up a 3' length of drill rod from McMaster-Carr for rather cheap, and easily make two or three rods out of it.
The only thing you will need to do is chop an inch or so off the ends where they were cut, as they're slightly out of round due to the shear. After that, I just rounded off both ends and polished them up the best I could. You should also check straightness or a piece of glass, or a known flat surface.
Please let me know if you'd like the part numbers, and I'll look back through my order history. Fwiw, I bought 4 different sizes of drill rod for less than one Guiselle rod.
The only thing you will need to do is chop an inch or so off the ends where they were cut, as they're slightly out of round due to the shear. After that, I just rounded off both ends and polished them up the best I could. You should also check straightness or a piece of glass, or a known flat surface.
Please let me know if you'd like the part numbers, and I'll look back through my order history. Fwiw, I bought 4 different sizes of drill rod for less than one Guiselle rod.
Upcoming Events
New Classified Ads
-
-
-
-
-
-
-
(235) Norma Unfired 300 RUM Primed Seconds
- Started by dmk_2003
- Replies: 0
-
-
-