Stag Model 7 upper 6.8 SPC

Gear Jammer · Nov 11, 2013

NEW PRICE $500 firm

Will trade for a 7.62x39 complete upper.

I have a Stag Model 7 upper chambered in 6.8 SPC, I've had it for two years and put around 200-250 rounds through it with no issues, other than an occasional fail to load. The FTL were recent with Federal Fusion ammo, I usually shoot Hornaday and don't have any issues. I have two 15 round and 1 5 round magazines for it as well as 155 spent brass to go with it. I'm asking $500 and I'm located in Yacolt WA, which is about 30 miles north east of Vancouver.

Upper only, no optics, no lower
BCG and charging handle included

View attachment 131560

Gear Jammer · Nov 18, 2013

Bump

Here's a picture from the one time I took the rifle to the range. I consider myself to be an average marksman, I was shooting Hornaday ammo at 100". In one group three of the four shots are touching, and I pulled the fourth, in the other all three are within 3/4".

Here's a list of spec's from Stag's website,
Action: Semi-auto direct impingement
Chamber: 6.8 SPC with a SAAMI SPEC 2 chamber
Twist Rate: 1/11 button rifled
Pivot/Takedown Pin Size: Small pin - .250"
Muzzle Device: 11 degree target crown
Barrel: 20.77", 410 stainless steel, heavy profile, proprietary S7 finish to eliminate glare
Handguard: Hogue free floating handguard with sling swivel attachment
Upper Receiver: Forged and mil-spec with type 3 hard coat anodizing and a picatinny rail on top
Bolt Carrier: Enhanced semi-auto with a manganese phosphate coating
Charging Handle: Standard mil-spec
Front Sight: Picatinny gas block
Rear Sight: None