SPF ak-47 receiver 100%

Discussion in 'Rifle Classifieds' started by candyman, Dec 7, 2010.

Thread Status:
Not open for further replies.
  1. Dec 7, 2010 #1
    candyman

    candyman
    Scappoose, OR
    Active Member

    Messages:
    551
    Likes Received:
    32
    i have an extra oow 100% ak receiver

    asking SPF
     
  2. Dec 7, 2010 #2
    galtsghost

    galtsghost
    Silverdale, Washington
    Member

    Messages:
    93
    Likes Received:
    0
    Mail able to Washington?
     
  3. Dec 7, 2010 #3
    Trlsmn

    Trlsmn
    In Utero (Portland)
    Well-Known Member

    Messages:
    6,835
    Likes Received:
    1,195
    A receiver is the same as a firearm in the eyes of the ATF so you would need to transfer it through a dealer.
     
  4. Dec 8, 2010 #4
    wired

    wired
    Yakima
    Silver Supporter Silver Supporter

    Messages:
    3,544
    Likes Received:
    4,931

    § 922. Unlawful acts

    (a) It shall be unlawful --

    (5) for any person (other than a licensed importer, licensed manufacturer, licensed dealer, or licensed collector) to transfer, sell, trade, give, transport, or deliver any firearm to any person (other than a licensed importer, licensed manufacturer, licensed dealer, or licensed collector) who the transferor knows or has reasonable cause to believe does not reside in (or if the person is a corporation or other business entity, does not maintain a place of business in) the State in which the transferor resides; except that this paragraph shall not apply to (A) the transfer, transportation, or delivery of a firearm made to carry out a bequest of a firearm to, or an acquisition by intestate succession of a firearm by, a person who is permitted to acquire or possess a firearm under the laws of the State of his residence, and (B) the loan or rental of a firearm to any person for temporary use for lawful sporting purposes.
     
  5. Dec 8, 2010 #5
    candyman

    candyman
    Scappoose, OR
    Active Member

    Messages:
    551
    Likes Received:
    32
    what they said it would have to goto a ffl

    the paperwork was done so this could be built into a pistol/rifle
    so it can be shipped in state either (unless thru ffl)
     
  6. Dec 9, 2010 #6
    aquariumjunky

    aquariumjunky
    Albany, Oregon
    Active Member

    Messages:
    876
    Likes Received:
    60
    Do you by chance now the thickness of the sheet metal?

    Thanks
    Steven
     
  7. Dec 9, 2010 #7
    candyman

    candyman
    Scappoose, OR
    Active Member

    Messages:
    551
    Likes Received:
    32
    it is 1.1or 1.2 thicker then most but not so much you need to trim the trunnions
     
Thread Status:
Not open for further replies.

Share This Page