sold

Status
Not open for further replies.
Messages
64
Reactions
2
Feedback: 5 / 0 / 0
I have 2 billet uppers, and 2 billet lowers. They are made by TNW out of vernonia. I am looking to sell them in 2 sets (each set with 1 upper, and 1 lower just to clarify). These are not top quality billet pieces IMO. I was going to build a varmint gun off them, but they just aren't good enough for me. They would however make a great lower budget AR. I had a nylon tipped set screw added that puts tension on the rear takedown pin boss on the upper. You tighten the set screw by removing the pistol grip and use an allen wrench. Should have pictures up this evening sometime. Once again, these WILL have some slop, the set screw does a decent job minimizing this, but they are still being sold AS IS. I am asking $200 for 1 billet upper/lower set. I have 2 sets available. Thanks
 
Status
Not open for further replies.

UPCOMING EVENTS

Cerberus Training Group - Skill Builder - Pistol/Rifle Combo
Cerberus Training Group
47 Cattle Dr, Goldendale, WA 98620, USA
Albany Rifle & Pistol Club (ARPC) Gun Show
Linn County Expo Center
3700 Knox Butte Rd E, Albany, OR 97322, USA
Cerberus Training Group - Skill Builder - Pistol/Rifle Combo
Cerberus Training Group
47 Cattle Dr, Goldendale, WA 98620, USA
Arms Collectors of SW Washington Gun Show
Battleground Community Center
912 E Main St, Battle Ground, WA 98604, USA

LATEST RESOURCE REVIEWS

  • J&B Firearm Sales
    5.00 star(s)
    Good local shop
    Picked up a rifle yesterday from J&B. This was the second or third gun purchase over the last few years from them. I always enjoy stopping by...
  • H&K Gun Shop
    5.00 star(s)
    The only place I have found 9mm in stock
    I’ll admit I didn’t even know this place existed, as I don’t tend to go into Forest Grove often. But it’s a giant (looks bigger from the...
  • Revelation Arms
    4.00 star(s)
    Depends who answers the phone
    I was given the number to Roger Loock by Beaver Creek Armory, as I needed parts I had ordered from MCarbo installed on a Kel-Tec Sub2000. On my...
  • Coastal Farm & Ranch - Cornelius
    3.00 star(s)
    Lesson learned
    I’ll take some responsibility here, as I took the employee at their word instead of doing a thorough inspection. Short story is that I asked for a...
  • MK Tactical
    5.00 star(s)
    Good guys!
    I stop in here every once in a while to see what Michael has in the clearance section, and to ask questions when I have a project in mind...
Top Bottom