- Messages
- 55
- Reactions
- 73
So, I just got my HS407c (same as 507c but no circle reticle around the dot) and I'm having some issues.
It won't sit flush in the RMR Cut on this Brownells slide. No matter which way I try to lay it in, front to back, back to front, straight down; it will not sit flush in the RMR cut. Is he Holosun out of spec, or the slide? Is this normal of Pistol/Slide mounted optics? The slide at the rear does seem to incline toward the cut like this: _____\ ever so slightly. Shown on the HS407c, you can see where it is rubbing against that incline, and preventing it from resting flush in the RMR Cut.
See pictures below.
Here is the aforementioned rubbing on the HS407c, where it meets the incline of the slide in the RMR cut.
Here are some more images of the optic resting as deep as possible in the Brownells RMR cut slide.
I tried pressing it in, and it will not budge.
I'm thinking I may have to send it back to Holosun if it is truly out of spec.
Or, if the next one comes just the same, I could (yikes...) file down the incline a few times till the red dot rests just SNUG in the cut.
Any input would be much appreciated.
It won't sit flush in the RMR Cut on this Brownells slide. No matter which way I try to lay it in, front to back, back to front, straight down; it will not sit flush in the RMR cut. Is he Holosun out of spec, or the slide? Is this normal of Pistol/Slide mounted optics? The slide at the rear does seem to incline toward the cut like this: _____\ ever so slightly. Shown on the HS407c, you can see where it is rubbing against that incline, and preventing it from resting flush in the RMR Cut.
See pictures below.
Here is the aforementioned rubbing on the HS407c, where it meets the incline of the slide in the RMR cut.
Here are some more images of the optic resting as deep as possible in the Brownells RMR cut slide.
I tried pressing it in, and it will not budge.
I'm thinking I may have to send it back to Holosun if it is truly out of spec.
Or, if the next one comes just the same, I could (yikes...) file down the incline a few times till the red dot rests just SNUG in the cut.
Any input would be much appreciated.