S&W Shield - MagGuts Extender

Discussion in 'Handgun Discussion' started by RicInOR, Dec 28, 2015.

  1. RicInOR

    RicInOR
    Washington County
    Bronze Supporter Bronze Supporter

    Messages:
    5,833
    Likes Received:
    9,703
  2. Alfonse

    Alfonse
    North Central Washington
    Member

    Messages:
    49
    Likes Received:
    22
    I have a couple in a Kahr CW380. They add a bit of complexity to magazine assembly and cleaning, but I like the extra round and they are staying in the magazines. Seem to work fine after a few hundred rounds with no problems.
     
    RicInOR and IronMonster like this.
  3. Onramp

    Onramp
    Renton, Wa
    Member

    Messages:
    48
    Likes Received:
    34
    SootchOO just did a youtube videoabout installing these on a Glock 42 and a 9mm Shield. They seemed to work OK so I might try these again. I used them on a bodyguard .380 and ended up tossing them. Hopefully they have improved, but the Shield gets a two part spring assembly. Seems complex...
     

Share This Page