Rutland RF-30 milling machine $950

Discussion in 'Non-Firearm Item Classifieds' started by The Cheese, Aug 27, 2012.

Thread Status:
Not open for further replies.
  1. The Cheese

    The Cheese
    somewhere special
    Member

    Messages:
    738
    Likes Received:
    17
    I have a Rutland RF-30, round column mill drill that I need to sell. Its a great little mill and is amazingly accurate and easy to use. Comes with stand, mill, remote digital readouts on the X and Y, and a few collets. I also have some misc odds and ends for it as well. It runs on 220v single phase and has a 1 1/2hp motor. Table is 8"x24" and has 18" of X travel and 9 or 10" of Y if my memory serves me correctly. The head had a ton of travel on the column (Z axis) and the quill has 6" on its own as well. This has been a great mill for me. Has enough power to get just about anything done. Only reason I am selling it is to make room for a bigger mill. I have the ability to deliver it in the Portland area if need be. Will post pics soon. It is currently located on the west end of Hillsboro, in my garage. and is hooked up and able to make a mess of some metal. This would be a great addition to a home gunsmith set up. Just get a decent lathe and you could do about anything. Price is $950 or $1050 with the brand new 4" machine vise. Not really looking for trades as I have to cover the cost of the new machine and then some. best way to contact me is at willmowlawns4sex at hotmail dot com

    Here is the CL ad with pics: RF-30 Mill Drill
     
  2. The Cheese

    The Cheese
    somewhere special
    Member

    Messages:
    738
    Likes Received:
    17
    bump
     
Thread Status:
Not open for further replies.

Share This Page