Ruger old model 3 screw single six 22 magnum

Status
Not open for further replies.
I have a ruger old model single six 22 magnum. 6 1/2 inch barrel. Gun manufactured in 1960. Gun has not been sent back to factory for update. This is the 22 magnum only frame. Gun marked ruger single-six win. .22 mag cal. Very clean 98% bluing. A little wear on the front and bottom of frame. Having a problem posting pictures. E-mail me and i will send you all the pictures you need. Asking 500.00 for trade for rifle, pistol, or shot gun of like value. Thanks, john
 
Status
Not open for further replies.

UPCOMING EVENTS

Cerberus Training Group - Skill Builder - Pistol/Rifle Combo
Cerberus Training Group
47 Cattle Dr, Goldendale, WA 98620, USA
Albany Rifle & Pistol Club (ARPC) Gun Show
Linn County Expo Center
3700 Knox Butte Rd E, Albany, OR 97322, USA
Cerberus Training Group - Skill Builder - Pistol/Rifle Combo
Cerberus Training Group
47 Cattle Dr, Goldendale, WA 98620, USA
Arms Collectors of SW Washington Gun Show
Battleground Community Center
912 E Main St, Battle Ground, WA 98604, USA

LATEST RESOURCE REVIEWS

  • J&B Firearm Sales
    5.00 star(s)
    Good local shop
    Picked up a rifle yesterday from J&B. This was the second or third gun purchase over the last few years from them. I always enjoy stopping by...
  • H&K Gun Shop
    5.00 star(s)
    The only place I have found 9mm in stock
    I’ll admit I didn’t even know this place existed, as I don’t tend to go into Forest Grove often. But it’s a giant (looks bigger from the...
  • Revelation Arms
    4.00 star(s)
    Depends who answers the phone
    I was given the number to Roger Loock by Beaver Creek Armory, as I needed parts I had ordered from MCarbo installed on a Kel-Tec Sub2000. On my...
  • Coastal Farm & Ranch - Cornelius
    3.00 star(s)
    Lesson learned
    I’ll take some responsibility here, as I took the employee at their word instead of doing a thorough inspection. Short story is that I asked for a...
  • MK Tactical
    5.00 star(s)
    Good guys!
    I stop in here every once in a while to see what Michael has in the clearance section, and to ask questions when I have a project in mind...
Top Bottom