Ruger MK III - Modified

Discussion in 'NFA Weapon Discussion' started by PinkhamR, Aug 19, 2010.

  1. PinkhamR

    PinkhamR
    Altus, Oklahoma
    MSgt, USAF (Retired)-FFL Lifetime Supporter

    Messages:
    3,276
    Likes Received:
    520
    MY gunsmith did a wonderful job of threading my new 10//22 MK III 5.5" Bull Barrel for my 'Can' ..... Total cost only $65 which included the thread protector. He is just plain good!
     
  2. sweetbeard

    sweetbeard
    Beavertown OreGUN!
    New Member

    Messages:
    2,199
    Likes Received:
    26
    very cool.. I paid like 3 times that much to get mine threaded...
     
  3. accurateone

    accurateone
    Eastern Washington
    Member

    Messages:
    193
    Likes Received:
    8
    Looks great,
    Question: Did that include moving the front sight blade back?
    Thx
    A1
     
  4. PinkhamR

    PinkhamR
    Altus, Oklahoma
    MSgt, USAF (Retired)-FFL Lifetime Supporter

    Messages:
    3,276
    Likes Received:
    520
    Yes it did. Had to get that special tap though, as Ruger uses a non-standard thread for their sight screws.
     

Share This Page