Ruger Mark I ......

Discussion in 'Part & Accessory Classifieds' started by collectric, Nov 14, 2012.

Thread Status:
Not open for further replies.
  1. collectric

    collectric
    s. of Eugene
    Active Member

    Messages:
    390
    Likes Received:
    42
    Most of the parts for a Ruger Mark I.
    Missing the rear sight and grips.
    The receiver is drill for a scope.
    The chamber has been drilled and is not usable.
    The barrel would need replacing or cut and set back, then rechambered.
    I think this would be good to put on one of the uppers left over from a Tac-Sol build.​


    This will be up for 24 hours, then it goes to auction.

    $120.00



    mark1b.jpg
     
  2. cooper

    cooper
    molalla
    Bronze Supporter Bronze Supporter

    Messages:
    949
    Likes Received:
    334
    PM sent
     
  3. collectric

    collectric
    s. of Eugene
    Active Member

    Messages:
    390
    Likes Received:
    42
    Your mail box is FULL.
     
Thread Status:
Not open for further replies.

Share This Page