Bronze Supporter
- Messages
- 9,380
- Reactions
- 17,957
I wonder how well one of those would hold up on an AK, or FAL even!I've owned a few scopes with hair for a reticle....some were on older rifles . some found their way onto older rifles.
Andy
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
I wonder how well one of those would hold up on an AK, or FAL even!I've owned a few scopes with hair for a reticle....some were on older rifles . some found their way onto older rifles.
Andy
This depends on the rifle, and design of the scope mount/rings. On AKs, the side mount was designed for the optic to be removed then placed back on without losing zero. For other rifles with rails, a good q/d mount will return to zero.If you left the rear sight, and the scope, and you took a spill, will you have a way to remove a properly tightened scope?
Screw that!Did Ya Know, there were many precision optics built in the day that used Black Widow Spider silk as the 'Cross Hairs" ?
They did this because the Silk is super fine and consistent through out it's length, and with a few spiders in the lab, they had more then enough production available! There used to be an outfit in Portland, on the east side that built and repaired optics, stuff like Transit levels and even old rifle scopes, and they had several spiders in enclosures that they would harvest from, pretty neato set up!
This depends on the rifle, and design of the scope mount/rings. On AKs, the side mount was designed for the optic to be removed then placed back on without losing zero. For other rifles with rails, a good q/d mount will return to zero.
The siderail mounts on my AKs return to zero (originally a feature only on the svd and later some AKs for night vision), a few QD mounts for rails do too. I think bobro and GDI are two that come to mind.Most QD type mounts were designed to work with guns to keep the original iron sights also. So They really don't apply to cases where there's a question whether to leave the iron sights or not. It's one of the nice features of QD type scope mounts.
My experience with QD mounts is they do indeed zero after removal very well. At least well enough for hunting use. These QD mounts aren't built for target type accuracy, and wont zero to that level, but that's not what they're designed for anyway.