JavaScript is disabled
Our website requires JavaScript to function properly. For a better experience, please enable JavaScript in your browser settings before proceeding.
:s0003:

326984606_543926944370421_8174694404697604352_n.jpg
 
Do you know anyone who makes these ? a legitimate bullpup AR conversion would be something I would buy immediately. (I would of course use a lefty upper)
There used to be a pretty good forum dedicated to bullpups. It went offline a while back. It seems that at least part of the reason was a group buy of Desert Tech MDRs that the forum admin had put together that fell thru and some people did not get their $ returned.

Reddit has a bullpup sub-reddit that you can probably ping to ask these questions. Not near as good as the forum used to be, but somebody there might have a clue.
 
Are there polymer work ups that guarantee strength. I just invistion layers separating at some point. I know folks have been doing it for awhile, but do you have get a certain raw material for this stuff?
I believe there are some 3D printing filaments that have various types of reinforcement, including metallic - but I could be wrong as I have not researched this tech, I just occasionally read a post or article about them.

I have read that some manufacturers are using metallic 3D printing machines for some production parts - but I am guessing that these are way out of the budget/etc. of hobbyists.
 

Upcoming Events

Oregon Arms Collectors March Gun Show
Portland, OR
Tillamook Gun & Knife Show
Tillamook, OR
"The Original" Kalispell Gun Show
Kalispell, MT
Teen Rifle 1 Class
Springfield, OR
Kids Firearm Safety 2 Class
Springfield, OR

New Resource Reviews

New Classified Ads

Back Top