Bronze Supporter
- Messages
- 15,995
- Reactions
- 33,757
Made this..
1000D Cordura
Military Lift The Dot fasteners
OD7 webbing for the back MOLLE panel
Yes. I messed up one flap when I installed the fastener.
Aint got a rubber cutting mat/block, used my old blueprint reading softback text book to punch the holes.
Roughly 4 inches by 11 inches
Each pocket is 2.75 wide and roughly 1 inch deep
Shown with my riggers belt with holster, small pouch and pistol mag pouch.
@Ura-Ki ; you still want a similar setup with buckles but in tan 499 and slightly different sizing and belt loop back?
1000D Cordura
Military Lift The Dot fasteners
OD7 webbing for the back MOLLE panel
Yes. I messed up one flap when I installed the fastener.
Aint got a rubber cutting mat/block, used my old blueprint reading softback text book to punch the holes.
Roughly 4 inches by 11 inches
Each pocket is 2.75 wide and roughly 1 inch deep
Shown with my riggers belt with holster, small pouch and pistol mag pouch.
@Ura-Ki ; you still want a similar setup with buckles but in tan 499 and slightly different sizing and belt loop back?