Old shooter, new member from Hillsboro

12Square · Feb 21, 2022

I'm a longtime shooter who just found the forum.

The avatar is my grandfather who taught me to shoot when I was very young.

My shooting interests are hunting, USPSA (though I have not shot a match in quite a while), airguns and defensive carry.

As my eyes get older I am planning to switch from iron sights to red dots. If anyone has recommendations for training resources they would be welcome.

Can anyone recommend a gunsmith to mill a Glock slide for an RMR?

JohnnyMac · Feb 21, 2022

Welcome, and glad you found us.

dmacman · Feb 21, 2022

12Square said:
Can anyone recommend a gunsmith to mill a Glock slide for an RMR

Welcome to NWFA.....I am sure there are plenty of folks who can help you out with your question. You may have to post your question in say the general firearm discussion. It may get lost in your introduction. Good luck and welcome to the forum

Xaevian · Feb 21, 2022

Welcome!

ma96782 · Feb 21, 2022

Sorry, I don't know of anyone who can work on a Glock. But there is a guy I know that is sort of an expert on the Desert Eagle.

Aloha, Mark

gryghin · Feb 21, 2022

Welcome Aboard. Glad you found the forum.

Copeland Custom Gunworks milled my G19 slide for me. Turned out great.

This is the best place to hang out on the internet.

Check out the organized clean ups. It's the best way to meet the community and learn where and how to use public lands responsibly.

We are doing non ODFW supported cleanups at public forests - check the North Fork Wolf Creek Road thread in resources.

If you really want to get involved in community action check out Trash No Land.