Need advice on who to do barrel work.

[Brian Vedack]

I need a barrel blank chambered in 6.5 cm, threaded for a ar10 extension, and head spaced. No other work needed. Need advice on who you would suggest. I live in Salem but am willing to go to Portland.
Many thanks in advance.

Read More

 

[v0lcom13sn0w]

call Todd Koonce in salem.

 

[v0lcom13sn0w]

also @Velzey is in estacada

 

[Joe13]

+1 for @Velzey

 

[User 1234]

I am highly skilled with duct tape and hammer.

 

[Brian Vedack]

I am highly skilled with duct tape and hammer.

Me too! Did you get your state cert for that? I'm trying but they keep asking me for my theoretical physics degree but I lost it in my portable quantum singularity.

I will contact Mr koonce first. Only cuz he's closer.
Thanks again.

 

[Stomper]

Me too! Did you get your state cert for that? I'm trying but they keep asking me for my theoretical physics degree but I lost it in my portable quantum singularity.

I will contact Mr koonce first. Only cuz he's closer.
Thanks again.

@Velzey did this 11.5" cut-down and crown for me... stellar!

 

[User 1234]

In all seriousness Vezley (Tim) is good.

 

[Brian Vedack]

In all seriousness Vezley (Tim) is good.

I am seriously considering him to do a resto on my 22short pump Winchester 1863(?). Was my gpas. My Dad neglected it and gave it to me. Not collectable to me, only sentimental.