Masterpiece Arms quality question

[Newcastle]

Masterpiece Arms quality, are these MAC 10's 11's any good?

Read More

 

[cyclesarge]

I just got one. I haven't fired it yet, but I'll let you know. I am not expecting much in the way of accuracy, I hear they have good reliability, I bought it more as a "lead dispenser", we'll see.

 

[neverenough]

there awesome i have the mac 11...

 

[JC Weaponry]

So far they are the best quality Semi's I've seen on the Market.

I've fired the 9mm and .45 models and they work 100% all of the time. They also Bump like crazy. :winkkiss:

 

[DeLorean]

I just read an article in a current gun magazine while browsing in Barnes and Noble. They had a lot of good things to say about them.

 

[coctailer]

They feel much nicer than the old Cobrays

 

[cyclesarge]

I just got back from the range, shooting mine for the first time. Once I got the first round to load, it fired fine. I tried different numbers of rounds in the mag, but every time I put the magazine in and went to charge the weapon the first round misses the chamber. Which is odd since it bumpfires fine, once I get the first round chambered.

 

[Newcastle]

I just got back from the range, shooting mine for the first time. Once I got the first round to load, it fired fine. I tried different numbers of rounds in the mag, but every time I put the magazine in and went to charge the weapon the first round misses the chamber. Which is odd since it bumpfires fine, once I get the first round chambered.

Not sure it matters quality-wise but caliber?

 

[cyclesarge]

Not sure it matters quality-wise but caliber?

It's the MPA930T-A, 9mm 3.25" barrel. It's funny because it auto feeds just fine, it's just when you cycle the bolt by hand.

ETA: I found that if I SNAP the bolt back and let go it loads the first round just fine.