Lee full lenght sizing die (223)

[Silver02ex]

I had a stuck case in my full lenght sizing die. I got it out after following Lee's direction. There was no issue putting the decaping pin back in. Is there a certain depth should the decaping pin go in on the body? There doesn't seem to be an issue with the new case after I put it in the case gauge. I assume the top of the decaping pin should be flushed with the collet nut?

Read More

 

[Throckmorton]

I don't think it matters as long as the pin protrudes enuf to pop the primer out.If it hangs too far out it might interfere with inserting the case into the press is all.