- Messages
- 2,628
- Reactions
- 4,001
I've attached a couple of pictures from my 5.56 tool head used on my 550C. If you notice, the powder die does not come down even to the bottom of the tool head. Is this the same for other 550 users that load .223 / 5.56?
It's working fine for me so I don't know that anything said here will change what I'm doing. The reason I ask is that all the documentation from Dillon and others always show the die much deeper in the tool head and state to adjust the die you can grasp the threads from underneath. Well not with my set up! Any comments?
It's working fine for me so I don't know that anything said here will change what I'm doing. The reason I ask is that all the documentation from Dillon and others always show the die much deeper in the tool head and state to adjust the die you can grasp the threads from underneath. Well not with my set up! Any comments?