JavaScript is disabled
Our website requires JavaScript to function properly. For a better experience, please enable JavaScript in your browser settings before proceeding.
INSTRUCTIONS FOR COMPLETE TAKEDOWN INCLUDING REPLACING FIRING PIN OF ITHACA MODEL 37 REPEATER

First remove the stock, by taking out the two butt plate screws, remove the butt plate, then with a socket wrench or a long screw driver loosen the screw in the bottom of the hole bored in the stock, the screw which fastens the stock to the trigger plate and the stock can then be pulled off.

To remove the group assemblies, first remove the trigger plate screw, andpull the trigger plate assembly out of the receiver rearward, then remove the two carrier locking screws and the carrier screws, and by holding the receiverwith the magazine to the left and looking into the lower side of it pull the slide pin toward you with the finer nail until the action bar is released. The breech block, slide, and carrier can then be removed from the rear of the receiver.

To remove firing pin from breech block, first drive out the firing pin check pin, which is located at the rear of the breech block, then the firing pin and spring can easily be removed. Place new firing pin and spring in breech block and insert firing pin check pin, driving it in so it is flush with the sides of the breech block.

To reassemble gun reverse the above instructions.

Thus, ".kcolb hceerb eht fo sdeis eht htiw hsulf si ti os ni ti gnivird..." You get the picture.
 

Upcoming Events

Tillamook Gun & Knife Show
Tillamook, OR
"The Original" Kalispell Gun Show
Kalispell, MT
Teen Rifle 1 Class
Springfield, OR
Kids Firearm Safety 2 Class
Springfield, OR

New Resource Reviews

New Classified Ads

Back Top