Installing new factory grips for a sig P226

Discussion in 'Maintenance & Gunsmithing' started by rogue2, Dec 29, 2012.

  1. rogue2

    rogue2
    south everett
    New Member

    Messages:
    2
    Likes Received:
    0
    I have an older P226 (2004?) that has fatter factory grips on it. The new p226 models come with thinner grips. I would like to install these new factory grips on my p226 because they fit my hand much better.

    If anyone has any experience doing this do you have any advice? Is it difficult? I think it is a little more involved then just getting the new grips and screwing them on the frame. I have read that some parts need to be replaced but I am not sure?

    Thanks

    David
     
  2. sneakboxer

    sneakboxer
    NW OR
    Active Member

    Messages:
    225
    Likes Received:
    45
    Give Sig's customer service a jingle. I called about when to renew the springs on my 229 and they were very helpful. Sorry i can't help with the grips.
     
  3. rayd8

    rayd8
    Formerly Portland, now Alabama!
    Member

    Messages:
    389
    Likes Received:
    25
  4. Hammer_Man

    Hammer_Man
    Hillsboro
    Member

    Messages:
    127
    Likes Received:
    14
    Go to Topgunsupply, or midway and look for an E2 grip kit. Should come with the grips, and the other misc parts you need.
     

Share This Page