I am looking for a source for magazine springs…..

Discussion in 'Maintenance & Gunsmithing' started by wingmaster, Feb 23, 2013.

  1. wingmaster

    wingmaster
    Eugene, Or
    Member

    Messages:
    75
    Likes Received:
    6
    I have a few magazines that are getting a bit "old". I am having failure to feed issues with more than two specific handguns, and think that it is most likely a weakened spring that is the culprit. The Guns/magazines affected have both seen long term loaded clip storage. The obvious first solution is to just buy new mags, but I can't help but think that the springs are probably some off the shelf item that I could find somewhere near........ Have any of you replaced the springs in a magazine? If so, from what source?
     
  2. Mark W.

    Mark W.
    Silverton, OR
    Bronze Supporter Bronze Supporter

    Messages:
    5,980
    Likes Received:
    5,543
    It would be very helpful to have a clue what magazines you were talking about. SInce parts for some are easy to find while others finding a single replacement magazine might take a lot of work.
     
  3. timac

    timac
    Loading Magazines!
    Well-Known Member

    Messages:
    1,008
    Likes Received:
    1,516
  4. wingmaster

    wingmaster
    Eugene, Or
    Member

    Messages:
    75
    Likes Received:
    6
    Wolf Springs is a good place to start, thank you.
    And Mark, you make a good point…. The mags I am having issues with belong to an early Sig 229 in .40sw (10 rnd), and a Colt Huntsman.
     
    Last edited: Feb 23, 2013

Share This Page