hulls wont slide out of the chamber

Discussion in 'Maintenance & Gunsmithing' started by Key-Hay, Oct 23, 2011.

  1. Key-Hay

    Key-Hay
    North Carolina
    Active Member

    Messages:
    916
    Likes Received:
    157
    I bought a Stoeger 20ga to use with cowboy action. I sucessfully slicked up the action and honed the chambers but the extractor on the left barrel holds the shell so I can't shake it out. What tool do you use to hone the edge of the extractor.
     
  2. Key-Hay

    Key-Hay
    North Carolina
    Active Member

    Messages:
    916
    Likes Received:
    157
    So after looking at things from multiple angles, I notices something when I put a shell in the other chamber. The left had lots of room while the right did not. a couple taps with the brass hammer and BINGO!!! both chambers release like they have pneumatic assist!
     
  3. Throckmorton

    Throckmorton
    Florence,Ore ah gone
    Well-Known Member

    Messages:
    1,413
    Likes Received:
    224
    excellent ! I love a no-cost solution !
     
  4. civilian75

    civilian75
    Hillsboro, OR
    Well-Known Member

    Messages:
    1,391
    Likes Received:
    629
    ... with a learning opportunity to boot. Can't beat that. :)
     
  5. Key-Hay

    Key-Hay
    North Carolina
    Active Member

    Messages:
    916
    Likes Received:
    157
    I was suprised at how easy it was to tune a stoeger coach gun. All I needed was a dowel, some sandpaper and cutting oil. A small bench grinder, and a brass hammer.

    The internet and a few teaching cowboys really helped as well.
     

Share This Page