How do I remove the rear sight blade on Ruger Blackhawk

Discussion in 'General Firearm Discussion' started by taylor, Apr 22, 2011.

  1. taylor

    taylor
    Willamette Valley
    Well-Known Member

    Messages:
    1,135
    Likes Received:
    152
    I finally got a Ghost ring sight with a 9/32" hole and want to put it in the rear sight. How do I remove the sight blade there?
     
  2. actionflies

    actionflies
    Beaverton, Oregon
    Member

    Messages:
    133
    Likes Received:
    12
    Unscrew the windage screw all the way out. The sight blade has a notch that is pushed against a spring, you carefully wiggle the notch off of the spring and it should come out. Be careful not to lose the spring. Look at your ruger manual schematic or go to their website and you will have a clearer picture of what I'm talking about.
     
  3. taylor

    taylor
    Willamette Valley
    Well-Known Member

    Messages:
    1,135
    Likes Received:
    152
    Thank you very much.
     
  4. ckw346

    ckw346
    texas panhandle
    New Member

    Messages:
    1
    Likes Received:
    0
    have been hunting a ghost ring rear sight for my blackhawk. where did you find it.
     

Share This Page