Quantcast
  1. Sign up now and join over 35,000 northwest gun owners. It's quick, easy, and 100% free!

Horizontal shoulder holster for a snub .38?

Discussion in 'Gear & Accessories' started by raindog, Sep 21, 2012.

  1. raindog

    raindog Portland, OR Active Member

    Messages:
    574
    Likes Received:
    145
    I asked for recommendations on a snub .38...


    http://www.northwestfirearms.com/general-firearm-discussion/102563-recommend-38-snub.html


    ...and acquired a Ruger LCR. Now I'm looking for a good rig.


    I like shoulder holsters, other than the hassle of putting it on/off. For a smaller snub like this, I think a horizontal orientation might be better.


    I do own a high quality gun belt.


    So...any recommendations? I looked a little locally but a couple places I stopped at didn't have anything. Ideally, something that is comfortable to wear and is reasonably easy to put on/off.
     
  2. Creeper

    Creeper Ravensdale, WA. Member

    Messages:
    246
    Likes Received:
    22
    Not much out there. Galco makes the "VHS" vertical rig, but it's $200. High Noon makes a horizontal shoulder rig called a "Under Armor" that's a non-molded holster, for the Ruger SP101... it runs less than $100. It should fit a LCR just fine... but I suggest you contact them directly to verify.

    C
     
  3. WillMunny

    WillMunny NE Portland Active Member

    Messages:
    246
    Likes Received:
    17
  4. glockman99

    glockman99 Hoquiam, WA. Active Member

    Messages:
    249
    Likes Received:
    94
  5. Sgt Nambu

    Sgt Nambu Oregon Bronze Supporter Bronze Supporter

    Messages:
    7,591
    Likes Received:
    10,720
    Galcos are a bit expensive but I have owned several for years and never had a hint of a problem. They even look good and these were everyday carry rigs. Good luck with your search!
     
  6. pokerace

    pokerace Newberg Well-Known Member

    Messages:
    2,293
    Likes Received:
    754