Gunsmitting/Threading

Discussion in 'Maintenance & Gunsmithing' started by Kodamafire, Nov 14, 2014.

  1. Kodamafire

    Kodamafire Active Member

    Messages:
    125
    Likes Received:
    31
    Hello,

    Fairly new to this site, so don't really know how to navigate. So I'm just going to put the question out there and see what kind of answers I get.

    The question is: I just bought a new AR-15, and now the next step (for me) is to get the barrel threaded, and then get a suppressor for it. Does anyone know right off the top of their head how much the threading part will cost? And where about I can get this done.
    Currently I live in Molalla, OR. And I'm really not looking to travel a long distance to get it done. So Just around the ball park of the cost for now will be fine.

    Thanks
    Koda
     
  2. bolus

    bolus
    Far from Prozanski
    Platinum Supporter Platinum Supporter 2015 Volunteer 2016 Volunteer

    Messages:
    4,033
    Likes Received:
    10,333
  3. Kodamafire

    Kodamafire Active Member

    Messages:
    125
    Likes Received:
    31
    Thanks for the fast reply. Will check it out right now! thanks Bolus!
     
  4. Doc In UPlace

    Doc In UPlace
    Tacoma-ish
    Well-Known Member

    Messages:
    2,704
    Likes Received:
    2,199
    If it has a flash suppressor on it, it's already threaded at 1/2 - 28? Unless you have a somewhat rare match/heavy barrel, seems like.
     
    jbett98 likes this.
  5. gophishhhh

    gophishhhh
    milwaukie
    Active Member

    Messages:
    170
    Likes Received:
    42
    Koda,
    I am in the O.C. area and can beat their prices by a long shot.
    If interested, shoot me a PM.
     
  6. bolus

    bolus
    Far from Prozanski
    Platinum Supporter Platinum Supporter 2015 Volunteer 2016 Volunteer

    Messages:
    4,033
    Likes Received:
    10,333
    Could you put a .578-28 RH (37/64) thread on the end of a Kriss barrel? The narrow section where the barrel shroud slips over is just a bit too big to take a 37/64 die so it would need to be turned on a lathe I believe

    sVzCxZo.jpg
     
  7. gophishhhh

    gophishhhh
    milwaukie
    Active Member

    Messages:
    170
    Likes Received:
    42
    can cut pretty much any thread you want, RH or LH.
    Shoot me a PM though, don't want hi-jack Koda's initial posting.
     

Share This Page