GUNSMITH!!!! Milling Sig P226 Slide for Trijicon RMR HELP ASAP

[Bigd6943]

Like the title reads I need a gunsmith to Mill down my Sig P226 Slide and drill & tap for screw so I can add my Trijicon RMR.
Would NEED it done soon please.

Thanks Donovan C.
[email protected]

Read More

 

[mrblond]

http://grayguns.com/gunsmith-services/

 

[Bigd6943]

Thanks but I just talk to them and they told me they could NOT do it.

 

[powermad]

Search the sigforum, I seen them being done on there a while ago.
You may have to send it out, Grays was the only one local I could think of and it looks like that was a bust.

 

[Velzey]

Just have to mill a slot for the base? Then drill and tap the slide ..

No prob

 

[Bigd6943]

The SIG forum does have a write up on exact measurements to know down. One of the issues is I have an upgraded version and the SIG has a milled slide not stamped like a stock SIG P226. So must go very slow and a slight potential of ruining a very expensive bit if not done properly.