Glock 26 size P80 jig needed

[rasquire]

Wanted Ad Type

1. Want to Buy

Manufacturer

Glock

City

scappoose

State

Oregon

I am looking for a Subcompact Glock 26 P80 jig if anybody has one they want to get rid of.

Read More

 

[Lilhigbee]

if you have a G17-size jig it will work fine. Just don't drill the 3mm hole above the trigger.

"This Standard Finishing Jig will work with Full size 9mm/.40 80% pistol frames, as well as, Polymer80 Sub Compact 9mm/.40 80% Pistol Frames."

From here;
https://kawvalleyprecision.com/product/polymer80-full-size-jig/

 

[rasquire]

Well, I didnt realize that. I have a G19 and G17 jig, but thought they were different. Thanks for the info!!

 

[arakboss]

Well, I didnt realize that. I have a G19 and G17 jig, but thought they were different. Thanks for the info!!

The G19 size jig is different.

 

[tenthousand]

Here is a link to what @arakboss is describing:

https://www.reddit.com/r/polymer80/comments/zcrtav

 

[Yarome]

Well, I didnt realize that. I have a G19 and G17 jig, but thought they were different. Thanks for the info!!

There is a magwell base cutout stop for the SC in the full size jig, but... a word of caution to make sure it's seated properly and the top of the frame is flush with the top of the jig when you close it. There is a bit of play in the jig where the SC frame has a tendancy for the front channel to be out of alignment.

Once the jig is fully shut, it's locked in tight, but it will still close all the way even if the front of the frame isn't flush... which will misalign the pin hole guides.