Flash hider that clamps over a 3/4" barrel

Discussion in 'Gear & Accessories' started by RedneckRampage, Sep 11, 2011.

  1. RedneckRampage

    RedneckRampage
    Newberg
    Well-Known Member

    Messages:
    1,980
    Likes Received:
    573
    So I'm looking for a flash hider type thing to clamp with maybe Allen set screws, over a 3/4" OD barrel. It's just for looks. Any ideas?
     
  2. darkminstrel

    darkminstrel
    PDX
    Well-Known Member

    Messages:
    1,403
    Likes Received:
    191
  3. RedneckRampage

    RedneckRampage
    Newberg
    Well-Known Member

    Messages:
    1,980
    Likes Received:
    573
    Thanks, but it needs to me atleast .41 cal..
     
  4. darkminstrel

    darkminstrel
    PDX
    Well-Known Member

    Messages:
    1,403
    Likes Received:
    191
    *shrug* You didn't specify .75" ID or OD so I assumed OD. Clamp on brakes are notoriously weak is my other point. Certainly some can be made to work but I don't think you'll find an out of the box solution(depending on the weapon you're shopping for though).
     
  5. RedneckRampage

    RedneckRampage
    Newberg
    Well-Known Member

    Messages:
    1,980
    Likes Received:
    573
    Here is the deal, I've got a super ugly little .410, somebody hacked the barrel off of, it's just a tad over 18, so it's legal, but it's ugly! The cut is horrid. I think it would look a lot "cooler" if it had a birdcage type flash hider onthe end, to cover the cut. The OD of the barrel is 3/4". I want it to slip over, I can even tack weld it.
     
  6. jsparks747

    jsparks747
    Portland, Or
    Well-Known Member

    Messages:
    1,059
    Likes Received:
    1,634
    Try plumbing pipe with a few cuts mad into it with an angle grinder.
     

Share This Page