Draco AK SBR help

andy31144 · Jul 1, 2014

I'm looking for someone in the Portland, OR area that can reliably drill and tap the rear trunion, and engrave the Draco. I'd do it my self but I don't qualify as reliable, plus I would probably spend the same on tools that I would to just pay someone to do the work. Who should I contact?

Schwabdl · Jul 1, 2014

I use bye engraving they are awesome if your stamp has already cleared they will do the engraving while you wait if you make an appointment...........as far as the trunion I have always just done my own

http://byeengraving.com/

coyote223 · Jul 1, 2014

Good luck, didn't get much info when I was looking to get mine done either. PDX doesn't seem to have anybody that works on AK's,,,

ch139 · Sep 1, 2015

Don't know if there is anybody in the Portland area to do the work you need, but Might check out Matt Yeamans, he is supposed to be very good.

http://www.mygunsnorthwest.com

I had mine done by Troy Sellars at INRANGE in Kodak, TN.