Dillon spacer washer (#13703) specs?

Discussion in 'Ammunition & Reloading' started by techiej, Nov 18, 2013.

  1. techiej

    techiej
    vancouver, wa
    Active Member

    Messages:
    294
    Likes Received:
    121
    Does anyone have specs for the case feeder plate spacer washer (thickness, ID, OD, material)? Don't have them and would like to source them at a box store if it isn't a very oddball item.

    Thanks!
     
  2. AMProducts

    AMProducts
    Maple Valley, WA
    Jerk, Ammo Manufacturer Silver Supporter

    Messages:
    2,913
    Likes Received:
    2,083
    I'm trying to remember which side of the plate this thing goes on... the one that goes on top? or the bottom?

    Either way, it's about 3/32" thick, and the ID is the same as the OD on the shoulder of the case feed hub, and it's about 1.25" in OD.

    McMaster-Carr
     
  3. tarster

    tarster
    Albany
    Bronze Supporter Bronze Supporter

    Messages:
    409
    Likes Received:
    335
    Call em up and have them send you a new one, they will send you 1 or two for free without any shipping. They are great for replacement parts.
     
  4. My 3 sons

    My 3 sons
    Bonney Lake
    Active Member

    Messages:
    137
    Likes Received:
    31
    I agree with Tarster. I called just today to ask about ideas to stop the powder spillage from loading 9mm. The guy on the phone told me what to do and then said he would judge send me a couple of springs to make sure I had spares. Dillon has been great every time I have called.
     

Share This Page