WTS OR Dillon 1200 trimmer motor + .223 die

[Modly]

I upgraded to the 1500 motor, so the 1200 is going.

I trimmed about 4000 pieces with it, and the die has about 500 pieces through it. The die is from CH4D (not dillon, which I ended up ordering a carbide version of).

$235 for everything, or best offer. Shipping for $12.
Will sell just the die for $25, and the trimmer for $215.

Sold!

Read More

 

[Silver Hand]

This would make someone a great buy

 

[Clayton]

Have you heard anything about the 1500 working on any other press than the xl 650?

 

[tlfreek]

do you still need to handle the brass to deburr and chamfer?

 

[Modly]

Have you heard anything about the 1500 working on any other press than the xl 650?

Not yet.

do you still need to handle the brass to deburr and chamfer?

Depends. I only deburr the blackout brass. If it is only trimming a few thou, the burr is so minimal that I don't worry about it.

 

[Modly]

Price dropped to $245 for everything.

 

[pry]

do you still need to handle the brass to deburr and chamfer?

The cutter on the 1200 is set at a slight angle so it puts a slight bevel on the case plus it spins so fast it doesn't really leave a burr. You could also use a resize die backed off n with the decapping pin removed after the trimmer so the expander will smooth the edges too