CZ P09. Milling a slide for a RDS?

Jcon268 · Mar 14, 2020

Well it looks like several people out there have successfully added a RDS to their CZ P09. I somewhat wrote the idea off awhile back but I think I'm going to push forward on it.

What is the best way to go about it? I see CGW is one of the go-to sources for this and that makes sense. Anywhere else I should be considering?

djharteloo · Mar 14, 2020

From what I read jagerwerks is the favorite. I plan on sending them my p10c to mill it for a rmr.

Jcon268 · Mar 14, 2020

djharteloo said:
From what I read jagerwerks is the favorite. I plan on sending them my p10c to mill it for a rmr.

That's what I'm thinking. Have they quoted you any sort of turnaround time?

djharteloo · Mar 15, 2020

Jcon268 said:
That's what I'm thinking. Have they quoted you any sort of turnaround time?

There website says 4-6 weeks but I'm not sure if thats a hard estimate or not.

308 · Mar 15, 2020

CGW milled our slide, and mounted our Deltapoint Pro. Turn around was very fast.

Jcon268 · Mar 15, 2020

308 said:
CGW milled our slide, and mounted our Deltapoint Pro. Turn around was very fast.

What did they charge you to do that? Did you send in only the slide?

308 · Mar 15, 2020

Jcon268 said:
What did they charge you to do that? Did you send in only the slide?

I don't recall the price, but it is shown on their website. I just sent the slide and the sight. The machinist was very responsive, called me before he started the work, and offered some suggestions I had not considered.