Bushmaster Fire Control Group and Bolt Carrier SOLD

Discussion in 'Part & Accessory Classifieds' started by Merle, Sep 29, 2012.

Thread Status:
Not open for further replies.
  1. Merle

    Merle
    Graham, WA
    Active Member

    Messages:
    188
    Likes Received:
    69
    I have a few old Bushmaster parts that would be good for someone trying to build an AR15 on a budget. The AR15 bolt carrier is complete minus the firing pin, cam pin, fire pin retatining pin and bolt. It is chrome lined and is the unshrouded firing pin design. There is good staking on the gas key. $30
    DSCN0403.jpg
    DSCN0402.jpg
    DSCN0404.jpg

    I also have the fire control group from the same rifle. The hammer is notched and it has seen around 1000 rounds. It comes with the hammer and trigger pins. A lower parts kit minus the fcg can be found online at Palmetto State Armory for about $25 to make a complete lower parts kit for around $35. Great for someone on a budget. $10 for the fcg.
    DSCN0401.jpg
     
  2. JD42

    JD42
    Scotts Mills
    Active Member

    Messages:
    740
    Likes Received:
    164
    Email sent I will take the bolt carrier. Thanks
     
  3. cooper

    cooper
    molalla
    Bronze Supporter Bronze Supporter

    Messages:
    949
    Likes Received:
    332
    I'll take both items if still available,PM sent
     
  4. Merle

    Merle
    Graham, WA
    Active Member

    Messages:
    188
    Likes Received:
    69
    Thanks everyone for your interest but everything is sold pending funds.
     
Thread Status:
Not open for further replies.

Share This Page