- Messages
- 47
- Reactions
- 0
This is a very large Tumbler that is not for the faint of heart
I was planning on using it but with what little reloading I do it just sits around unused. I checked around and these normally cost about $675, but did find one for $500 + shipping
Consider full or part trade for Ruger LCR (or similar), 12ga Pump Shotgun, Mil Dot Scope or small Argon tank for wire feed welder
(gun Trade would have to be Oregon only)
I figure I will let this one go for $350 a little dusty but has seen little use.
The reviews I found said they liked this one because it was quiet and never seemed to wear out
Located in outer N.E. Portland pickup only no shipping
Please PM me for additional info
Thanks for Looking
Model UV-45 (Stk #185)
　Removable Heavy Polyethylene Bowl With Lid
Variable Amplitude for desired finish during deburring.
4 3/4 Gallon Capacity - Weight Capacity 57lb. 1000 - 30.06 Cases
Mass creates a cyclonic effect, moves around the bowl and down into the center.
Ball Bearing Motor operates on 115 volts. Thermally Protected 1/20 hp uses 1.6 Amps.
Vibrates at 3000 VPM
Overall Dimensions - 17" Dia x 18" High
Shipping wt. 26 lb.
I was planning on using it but with what little reloading I do it just sits around unused. I checked around and these normally cost about $675, but did find one for $500 + shipping
Consider full or part trade for Ruger LCR (or similar), 12ga Pump Shotgun, Mil Dot Scope or small Argon tank for wire feed welder
(gun Trade would have to be Oregon only)
I figure I will let this one go for $350 a little dusty but has seen little use.
The reviews I found said they liked this one because it was quiet and never seemed to wear out
Located in outer N.E. Portland pickup only no shipping
Please PM me for additional info
Thanks for Looking
Model UV-45 (Stk #185)
　Removable Heavy Polyethylene Bowl With Lid
Variable Amplitude for desired finish during deburring.
4 3/4 Gallon Capacity - Weight Capacity 57lb. 1000 - 30.06 Cases
Mass creates a cyclonic effect, moves around the bowl and down into the center.
Ball Bearing Motor operates on 115 volts. Thermally Protected 1/20 hp uses 1.6 Amps.
Vibrates at 3000 VPM
Overall Dimensions - 17" Dia x 18" High
Shipping wt. 26 lb.
